Max10: ADC no longer working which have .pof file

08 феб Max10: ADC no longer working which have .pof file

Disappointed, you should verify accomplish this action. Please click the confirmation hook up on your own email. You are able to re also-send throughout your profile.

• Intel Neighborhood
• Tool Support Community forums
• FPGA
• Automated Devices
• Max10: ADC not working which have .pof file

• Mark Thing once the Brand new
• Mark Material because Discover
• Float this topic to possess Current Representative

We suspect you really have that (or more) a little sluggish otherwise less than ranked provides

I’m already working with Max10M16DAF256 and that i have trouble with the ADC. sof document it really works okay. pof document this new ADC does not work more, we.e ADC information is usually zero, as the someone else section really works precisely.

While using

We have including seen that when programming with .pof file but still let the suppy voltage towards, the fresh ADC works. But after reset the supply voltage (turn fully off and on once more), it generally does not works anymore.

In case your latter then you need to confirm evaluate the manner in which you discharge the brand new ADC Internet protocol address regarding reset. Wait from inside the reset ‘a nothing longer’ following the power up. Disappointed this may voice a little unclear. This seems to be a frequent point into message board that does not appear to have acquired an obvious, credible provider.

If this is your own board you will need to check on the aforementioned and ensure new rails increase monotonically. There aren’t any sequencing standards if the cannot go up correctly – not conference the latest Tramp go out – the system have a tendency to kuuma tyttГ¶ Laostian misbehave. Refer to ‘Figure step three. Tracked Strength Supplies Ramp Up’ on the ‘ electricity management user book (

I also found a similar issue with Max10 ADC in another thread, however, as if you told you there isn’t any solution for it.

The brand new board are our very own worry about structure board. The issue is a large number of all of our boards will work good with “ .pof „-file, and some ones get this ADC state. Towards chat rooms which have ADC state, we examined in the methods of them chat rooms regrettably i missed any issue toward equipment. Such mentioned above, brand new forums are working which have “ .sof “ and also “ .pof „-file if likewise have voltage is obviously toward. Following the likewise have voltage was reset, brand new ADC does no more really works just like the other individuals continues to be functioning correctly.

This will make me believe more this dilemma are strength associated. You are obviously toward side of no matter what issue is provided you have functioning forums.

Could you just take a low working panel, disconnect the advantage supplies and you will strength it away from counter supplies? My personal concern is you to a below rated railway isn’t really to giving the inrush expected and dips resulting in the POR circuitry a great condition, hence (perhaps) isn’t recorded.

You will be right. Used to do specific data on the power provides to have Max10, and it also seems like the analogue also have requires a bit a lot of time up until it is at full current peak (we have been using Max10 dual also provide device, which means a few electronic provides and step one analog also provide).

As in Max10 Stamina management user guide, it appears as though just the history battery pack getting Max10 number (attached picture), so we made an effort to swtich with the analog have first and wait for it to-arrive maximum height, then switch on another a couple electronic offers, and this grab only couples hundred s to-arrive max height. This helps new maybe not-doing work ADC to become working sporatically (never working).

However when we capture a functional board (ADC usually work) and you can do the contrary sequence (we.age let two electronic provides on earliest, then your analog likewise have), the newest ADC remains performing (we expected that it should not really works any further).

Thus somehow the brand new ADC condition relates to the power likewise have series and also the ramp lifetime of strength supplies, but a definite explanation for it state might have been not discovered but really.