08 феб Max10: ADC no longer working which have .pof file
Disappointed, you should verify accomplish this action. Please click the confirmation hook up on your own email. You are able to re also-send throughout your profile.
- Intel Neighborhood
- Tool Support Community forums
- FPGA
- Automated Devices
- Max10: ADC not working which have .pof file
- Mark Thing once the Brand new
- Mark Material because Discover
- Float this topic to possess Current Representative
We suspect you really have that (or more) a little sluggish otherwise less than ranked provides
I'm already working with Max10M16DAF256 and that i have trouble with the ADC. sof document it really works okay. pof document this new ADC does not work more, we.e ADC information is usually zero, as the someone else section really works precisely.
While using
We have including seen that when programming with .pof file but still let the suppy voltage towards, the fresh ADC works. But after reset the supply voltage (turn fully off and on once more), it generally does not works anymore.
In case your latter then you need to confirm evaluate the manner in which you discharge the brand new ADC Internet protocol address regarding reset. Wait from inside the reset 'a nothing longer' following the power up. Disappointed this may voice a little unclear. This seems to be a frequent point into message board that does not appear to have acquired an obvious, credible provider.
If this is your own board you will need to check on the aforementioned and ensure new rails increase monotonically. There aren't any sequencing standards if the cannot go up correctly - not conference the latest Tramp go out - the system have a tendency to kuuma tyttö Laostian misbehave. Refer to 'Figure step three. Tracked Strength Supplies Ramp Up' on the ' electricity management user book (
I also found a similar issue with Max10 ADC in another thread, however, as if you told you there isn't any solution for it.
The brand new board are our very own worry about structure board.